Few wearable coatings should be known. It is a new type of functional coating with good sturdiness and wear resistance. It is usually used on metal surfaces or on lenses and glass. It is more wear-resistant and will not scratch any more. Well, Xiao Bian today to introduce to you the specific abrasion resistant coating What are the characteristics? Note the use of wear-resistant coatings which.

What are the characteristics of wear-resistant coatings

1. Adhesives are important raw materials for wear-resistant coatings. They can bind various components in the coating together very well. Their firmness is very strong. A variety of products can be used as long as the use of anti-abrasion coating has a very good protective film, will be firmly bonded together. The fluidity of the adhesive and the curability of the room temperature are relatively strong, which is very convenient for construction.

2. Lubricants can improve the wear resistance of the wear-resistant coating, which greatly reduces the friction between the coating and the wall, and is more convenient for construction. Can also make the brushing effect more glamorous.

3. The components of the enhancer are mostly copper oxide powder, quartz powder, and original iron powder and other metal powders, which can improve the surface hardness of the product and the mechanical strength of the coating to a certain extent, and can be improved very well. Anti-wear properties of paints.

Wear-resistant coating precautions

1. The wear-resistant coating is generally made by manual stirring and mechanical stirring. Normally, it is recommended to use mechanical stirring. The stirring time is usually 2-3 minutes. If manual mixing is used, two-thirds of the water must be added for 4 minutes of stirring before adding the remaining coating to stir until the effect is satisfactory. It is advisable to carry out the mixing process with as little as possible, but it must be completed within 30 minutes.

2. The construction method of the wear-resistant coating should be carried out from the top down as far as possible. During the plastering, it is necessary to press hard. And the thickness of each plastering is preferably 20mm, preferably not exceeding 30mm. The construction time is also stressful. It is best to control all the processes within 45 minutes. Therefore, the speed of each mixing and construction must be well controlled.

3, the use of wear-resistant coatings, but also under the weather conditions to carry out the construction, the general coating will reach the initial solidification state in 1-2 hours, after the calendering process. Calendering is the most important of all processes. After this treatment, the roughness of the anti-friction layer can be reduced, which is very good for smooth discharge.

Xiaobian conclusion: The above is the characteristics of the wear-resistant coating that Xiaobian introduced to you and the precautions for using it. We hope to help you. When you have the demand for wear-resistant coatings, you can also use the above content to introduce targeted use, so as to achieve the desired effect.

Wear-resistant coating

High temperature is easy to cause circuit safety problems, and the instrument in the circuit is no exception. In summer, as far as the frequency converter is concerned, which is indispensable for equipment control and speed regulation, the hot weather is the heat and hard injury of the frequency converter. A large number of studies and practices have shown that the failure rate of the converter will increase with the increase of temperature, the service life will decrease with the increase of temperature, and the service life of the converter will be halved with the increase of ambient temperature by 10 degrees. For this reason, high temperature is coming, how we use Fluoride Solution to effectively cool down? Please contact us by email.

Refrigerant For Inverter Controller

Cooler Refrigerant,Fluoride Solution For Inverter Controller,Perfluorinated Liquid For Inverter Controller,Refrigerant For Inverter Controller

Guangdong Giant Fluorine Energy Saving Technology Co.,Ltd , https://www.tuwtechs.com