Cam Lock,Tubular Cam Lock,Combination Cam Lock,Stainless Steel Cam Lock Nanjing Toutru Trading Co., Ltd. , https://www.tcdoorlock.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>Preparation in front of the “rolling bearing†device makes it bon voyage The pre-preparation of the "rolling bearing" device makes it bon voyage
The use of bearings in modern society is becoming more and more extensive; followed by; the bearing device has become a difficult problem for everyone to think about. The specific analysis before the bearing device can be used for reference. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
(1) Before the bearing device; the appropriate skill should be used to measure the skill requirements on the design drawings; view the machining quality of the shaft and the seat hole and related parts (such as dimensional accuracy, shape accuracy and appearance roughness).
(1) Before the bearing device; the appropriate requirements should be used to measure the skill requirements on the design drawings; view the machining quality of the shaft and the seat hole and related parts (such as dimensional accuracy, shape accuracy and appearance roughness, etc.).
(2) The shaft and the seat hole of the device are covered with bumps, burrs, rust spots or solid particles (such as wear debris, sand, soil), etc.; not only make the bearing device difficult and the device orientation is incorrect; and the solid particles If it falls into the bearing, it will have a grinding effect; when the bearing rotates, it will wear or scratch the outer surface of the bearing; therefore, it is necessary to carefully check it before the device; if any of the above defects are found; it should be corrected. For example, using oil锉 Remove burrs, bumps, rust spots; and use fine sand cloth to illuminate; as well as remove solid particles, dirt, etc.
(3) The surface of the device should be cleaned with a clean solution of gasoline, kerosene, toluene or xylene; and wiped with a clean rag; then coated with a thin layer of lubricant; this will make the device more convenient.
(4) Open the bearing package when the device is installed; immerse it in the above-mentioned gasoline and other liquids to gently change the hand; make sure to adhere to the frame; the rolling oil and the surface of the raceway are completely cleaned.
(5) When removing many bearings; first use hot oil with a temperature of 90-100 °C to melt the encapsulating oil; use the things without front and no debris to dig all the old oil; then rinse for a few minutes; then Rinse the oil with kerosene; remove it with gasoline at the most. After cleaning, clean it; put on the film and put the bearing on the clean cloth on the workbench or on the paper to dry.
(6) Pay attention to the sealed bearing can not be removed by this method; the inside of the seal should not be removed as it is.
Recommend to friends comments close window Bearing related knowledge Analysis of the precautions for bearing selection
NSK bearing packaging and methods
The fundamental type of FAG double row angular touch ball bearing development direction of rolling mill bearings
This article links to http://
Please indicate the bearing network http://
Previous: Skills for correct device cooperation and adjustment of high-speed bearings Next: NSK imported bearings oil film smooth handling skills
The pre-preparation of the "rolling bearing" device makes it bon voyage
Source: China Bearing Network Time: 2018-04-13