Square stem casters series , as a professional Chinese caster manufacturer ,with rich R&D experience , which enable us to customize according to client's request , Size of stem ,top plate wheel material , type of brake , just let me know what you want , Rich Industrial Caster series , various from rigid wheel caster , Swivel Caster and Brake Caster , full size series make us become one-stop caster services center for you . Square Stem Caster,Tpe Caster,Polyurethane Caster,Industrial Caster Zhejiang Lingda Caster Co., Ltd , https://www.ldcaster.com
I bought a smart dome camera and don't know how to install it? Today Xiaobian will teach you how to install a smart dome camera. The installation steps are as follows:
1. Dial the address code first According to the binary rules, you need to install the address code of the camera, then remove the passport, dial the address code, and assemble and restore.
Refer to the above method to install the smart dome camera, one step in place, install so easy!
Teach you how to install a smart dome camera
2, fixed ball machine bracket Before installation, we must first think about the orientation and angle that need to be monitored, choose the installation position, and fix the bracket.
3. Wiring Route the power cable, video cable, and control cable to the camera. It is required to be able to wear a rich 15CM from the camera holder.
4, test the power line voltage See if it matches the camera voltage, this is very important, otherwise it will burn the camera.
5. Install the camera Insert the camera cable into the camera bracket and fix the camera screw.
6. Wiring Connect the power cable, video cable (benefit BNC connector or crystal head), and control cables in a certain order. Connect the control lines at the optical transceiver/recorder to the same wiring sequence. The video cable is connected to the recorder.
7, test the camera to see if there is no image, the operation control camera rotates up and down and left and right.
8. Troubleshooting If there is no image, first check if the camera has power, and then check if the BNC/Crystal head is in good contact. If the camera cannot control the movement, check if the control line is in good contact, and then check if the control line wiring sequence is consistent.