Modern Magnetic Track Lighting consist of aluminum profiles with integrated electric wires.The voltage inside the track is 48v ,safety.So DC48V magnetic track lighting system can also be used in places within easy reach .Available accessories and angle connectors allow you to create complex systems not only on the ceiling .
How to use magnetic track lights to achieve various lighting methods? Now the use of magnetic lamp is often used in lighting design lamps, with the right will become a bright spot in the design, with the wrong will form a visual disaster. So how should we use magnetic track lights to achieve general lighting, key lighting, local lighting and decorative lighting?
1. Magnetic track lamp in general lighting (basic lighting, ambient light) Light fixtures mainly provide light to Spaces such as ceilings, walls, floors, curtains, etc.
Ceiling and ground belong to horizontal plane lighting, which can adopt immobile linear module (floodlight and grid). The floodlight module provides wide and uniform soft light for the environment, while the grid module is suitable for anti-glare and focusing on the tea table of the living room sofa to enrich the level of environmental lighting.
These two modules are also suitable for walls, curtains and other facades to achieve the rhythmic wall washing effect of light spots, which is similar to the effect of down lights and spotlights. It is necessary to pay attention to not mixing and matching to avoid light spots.
Magnetic track light, as the name implies, is to increase the magnetic connection structure on the basis of the traditional track lamp. On the advantages of the track lamp,it is more convenient to install and remove the lamp components, which is convenient for daily maintenance and maintenance.At the same time, because the Magnetic Track Rail is low-voltage power supply,the magnetic lights housing can be removed from the drive, so the track and lamps are more compact and delicate, in the case of power permits, according to the needs and uses, arbitrary splices of lamps and lanterns, more convenient and fast.The formation of a unique sense of design.
Magnetic Track Light, Led track lights,magnetic spotlight,magnet lamp Farwise Technology Co.,Ltd. , https://www.farwiselighting.com
Automatic limit eccentric shaft chamfering tool
The eccentric shaft shown in Figure 1 is a very important part of the offset press. Since the load on the shaft is relatively large, there is no empty sipe at the root of the φ18h7 section to avoid excessive stress concentration and break the shaft. In the machining, when the φ22h7 shaft surface and the φ18h7 eccentric shaft surface are ground, a ring of burrs and edges must be generated at the end of the φ22h7 shaft surface, and the sharp corner edges thus produced cause the assembly of the powder metallurgy bushing extremely. difficult. Since the eccentricity of φ22h7 and φ18h7 is 1.9±0.05mm, the radial difference at a_1 point