Brass Plated Steel Sawing Wire
Fine-gauge brass plated steel sawing wire
plays an irreplaceable role in the production of solar wafers. The thickness of
the silicon wafer cutting wire on the market is generally 120 microns. In order
to reduce the loss of silicon blocks, fine-gauge and high-strength consumables
are required as cutting accessories. According to the technology, ultra-fine
specification high-strength brass plated steel sawing wire is a necessity for
silicon wafer production. This Cutting wire as a consumable material is widely
used in energy and utilities, aviation, equipment fields. Such as, solar wafer
cutting, quartz material, monocrystalline silicon, polycrystalline silicon,
etc.
Brass Plated Steel Sawing Wire,Brass Coated Bare Wire,Brass Plated Sawing Wire,Brass Coated Sawing Wire Jiangyin Baoneng Precision New Material Co.,LTD , https://www.baonengwire.com
Common faults and analysis:
1, the encoder itself fails:
It means that the components of the encoder itself have failed, causing it to produce and output the correct waveform. In this case, replace the encoder or repair its internal components.
2, encoder connection cable failure:
This kind of failure has the highest probability of occurrence and is often encountered during maintenance. It should be a priority factor. Usually the encoder cable is open circuited, short-circuited or poorly connected. In this case, replace the cable or connector. Special attention should also be paid to whether it is due to the tightness of the cable and the looseness caused by loosening or disconnection. In this case, the cable must be clamped.
3, encoder +5V power drop:
It means that the +5V power supply is too low and usually cannot be lower than 4.75V. The reason for the low power supply is that the power supply is faulty or the power transmission cable has a large resistance and the loss is caused. In this case, the power supply must be overhauled or the cable must be replaced.
4. Absolute encoder battery voltage drop:
This kind of fault usually has a clear alarm. In this case, the battery needs to be replaced. If the memory of the reference position is lost, the reference point must be returned.
5, the encoder cable shield is not connected or off:
This will introduce interference signals, make the waveform unstable, affect the accuracy of communication, must ensure reliable welding and grounding shielded wire.
6, encoder installation loose:
This kind of failure will affect the accuracy of the position control, resulting in an overshoot of the positional deviation between stop and movement, and even a servo system overload alarm may be generated immediately after power on. Please pay special attention.
7, grating pollution This will reduce the signal output amplitude, must use a cotton wool stained with anhydrous alcohol to gently clean the oil.
Encoder Common Faults and Analysis
An encoder is a device that compiles or converts a signal or data into a signal that can be used to communicate, transmit, and store. The encoder converts the angular displacement or linear displacement into electrical signals. The former is called the encoder and the latter is called the encoder.