In order to cater to the consumers who are pursuing new trends, some new technological methods have emerged in the market, such as tile adhesives, colorful caulks, and leave-joint paving. Tile adhesive (also called dry sticking method), tiles do not need to be pre-soaked on the base surface without wet, as long as the basic conditions of the pavement can be better, so that the operating conditions have been greatly improved. However, ordinary tiles still have to be soaked in water, then how to prevent ordinary tiles from falling off? Clean the base layer before tiling If the walls have lime plaster, latex paint, wallpaper and other decorative objects, or dirt on the ground, must be cleaned, or the cement mortar and the grass-roots bond is not strong; In addition, if the wall itself has cracks, should do properly Only after the treatment can be tiled, so as to avoid future basic structural cracks caused by cracking or loss of the wall tiles; For the flatness or verticality gap is too big on the ground, walls, but also use cement mortar for leveling. The difference in the color of the tiles is also compared before the shop. Wall tiles should be fully submerged Because wall tiles have a high moisture content, this feature must be considered when pasting. The base layer before the tiling should be fully moistened with water, otherwise, the moisture in the mortar is quickly absorbed by the dried base layer and tiles, and the rapid solidification will affect the adhesion fastness. Otherwise, the tiles will absorb moisture from the cement so that the cement cannot function as an adhesive. Paving tiles must first be laid flat Laying non-cemented floor tiles on the ground, knocking them out, spreading the grout to the floor tiles, and laying them on the ground, with the four bricks flush in the diagonal position. The laying of the order is also stress. Posted floor tiles should be posted from the inside, such as the ground slope or floor drain, should pay attention to the direction of the slope to find the drainage; wall tiles should be laid from the bottom, for the sake of beauty, the bottom of the brick should be posted. After pressing the tiles, press the tiles. In addition, a wall cannot be attached to the top at a time to prevent the tile from being heavy and causing it to fall. Do not step on tiles for a short period of time. Tiles as much as possible bubble In summer, because the material is drier than normal, materials that need to be treated with foam water, such as floor tiles and ceramic tiles, need to be treated for a prolonged period of time so that the moisture content is close to saturation. In this way, there will be no water absorption from the cement due to the drying of the tiles during the bonding process, so that the bonding with the cement is not firm, and emptying or falling-off occurs, causing some unnecessary trouble for you. Tiles Tile Floor Tiles Cement Latex Paint Wallpaper Decorative Tiles Tiles
soap rack,soap holder,soap stand,stainless steel soap holder,steel wire soap stand,etc.Let your bathroom become more simple and upscale!Applicable to families, hotels, home stay and other places to use.
304 stainless steel never rust, will easy to clear, it's also very durable!
we are 15 year factory, we had big engineer team, and strong production line, can give you good serve and quanlity. Welcome to cooperation!
soap rack,soap stand,soap holder,soap dish,soap dish rack Shenzhen Lanejoy Technology Co.,LTD , https://www.grill-mesh.com
 Tao Yilang Ceramic Card Hardware
Summer decoration tips to prevent the tiles from falling off