The establishment of labor insurance products stores is not only simple as opening a store. Based on the special nature of labor insurance products industry, in the purchase of goods, the inspection of product quality has become an essential process. Only by strictly controlling the source's safety and security, can the interests of users be realized. Below, China Labor Safety Net Xiaobian teaches you several important items for the inspection of your hard hat:

1. Whether there is a special labor protection product safety sign;

2. Are there any instructions for use of the product, including shelf life, size of the headband, etc.;

3, hat lining, hat hoop, sweat absorption band, cushion, lining, mandible, locking card and other components are complete;

4, the width of the tie is not less than 10mm;

5, helmet weight does not exceed 430g;

6, the internal dimensions of the shell: length: 195-250mm; width: 170-220mm; height: 120-150mm;

7. Caps: 10-70mm;

8, wearing height: 80-90mm;

9, vertical spacing: not more than 50mm;

10, horizontal spacing: 5-20mm;

11, vents: When the cap shell vent holes, the vent area of ​​150mm2-450mm2;

12, impact absorption performance: After high temperature, low temperature, water immersion, ultraviolet radiation pretreatment after impact testing, the force transmitted to the head mold is not greater than 4900N, the shell must not have fragments off;

13, puncture resistance: After high temperature, low temperature, water immersion, ultraviolet radiation pretreatment puncture test, the steel cone shall not contact the surface of the head mold, the shell shall not have fragments off;

14, Mandibular band strength: The mandibular band destructive force force value should be between 150N-250N.

Copyright Statement: This article is an original website reporter's article. If you need to reprint please indicate the source.